Pure Sine Wave Inverter DC 12V/24V to AC 220V — 2000W / 3000W / 4000W / 5000W Solar Power Converter

Important safety and installation notes: This inverter is not designed for connection to the utility power grid — do not tie the inverter’s AC output into mains supply, and avoid direct contact with the AC output conductors. The battery paired with the inverter can supply more energy than the instantaneous consumption of the connected devices. Both AC output conductors from the inverter are live (hot); there is no built-in earth/neutral reference, so neither output conductor should be used as a ground. Install the inverter so it is connected directly to the load. Do not place an air switch (circuit breaker) or a leakage protection/RCD device between the inverter and the load — doing so may prevent proper operation and can damage the inverter. The inverter’s pure sine wave design supports inductive loads up to 95% capacity. DC cable requirements: the battery-to-inverter DC current is high, so avoid extending the battery cables. Use the original wiring from the battery output to the inverter whenever possible. If an extension is unavoidable, the extension conductor must be roughly twice the diameter of the original cable, and the extended run is recommended not to exceed 1 meter to prevent voltage drop and insufficient input current/voltage.