Pure Sine Wave Inverter DC 12V/24V to AC 220V — 2000W 3000W 4000W 5000W Solar Power Converter Voltage Transformer

Important safety and installation notes: This inverter must not be tied into the electrical utility grid — do not connect the AC output to mains power or attempt to parallel it with grid supply. The battery paired with the inverter can deliver more energy than the connected appliance actually consumes. Both AC output conductors from the inverter are live; there is no chassis grounding on these outputs, so neither should be used as a ground conductor. Connect the inverter directly to the load — do not install a circuit breaker, residual-current device (leakage protection), or air switch between the inverter and the load, as such devices may not provide proper protection and can damage the inverter. For inductive loads, the pure sine wave inverter can support up to 95% of its rated capacity. DC cable requirements: the inverter demands heavy-gauge battery wiring. Do not lengthen the battery cables with thin wire. Use the original wiring from the battery to the inverter; unauthorized extensions can cause inadequate input current/voltage. If an extension is unavoidable, the extension conductor must be approximately twice the diameter of the original cable. It is recommended that the battery-to-inverter cable length not exceed 1 meter.