Miumaeov TIG Welder Torch Water Cooling Machine System Welding Water Cooler 8L/2.1gal

Build to Last: The brass, aluminum foil, and carbon steel materials make this product corrosion-resistant, wear-resistant, and high in hardness, ensuring your long-term use without frequent replacement. Strong Cooling Capacity: The heat sink made of copper and hydrophilic aluminum foil and the 370W high-performance motor provide 1.5KW of heat dissipation power and 105 feet of lift, which achieves fast heat dissipation and more powerful output, helping you to significantly improve work efficiency. The heat dissipation holes on the casing of this product also ensure good heat dissipation and prolong the service life of the product. Scientific Working Principle: The water in the tank is introduced by the vortex pump and sent to the cooling channel inside the welding machine through the pipeline, thereby absorbing the heat generated by the welding machine and lowering the temperature. The cooled water is then returned to the tank to continue circulation. In this way, the cycle is repeated, and the heat generated inside the welding machine is continuously taken away, ensuring its normal working temperature, and preventing overheating damage. Notes Welding machines are not included in this package. Please use only distilled water, purified water, or antifreeze specifically designed for use with welder coolers, please do not use automotive anti-freeze fluid. Before use, please check all components for proper functioning to ensure safe operation. Please pay attention to potential safety hazards when using electricity. The use of tools requires special operation qualifications. Please read the manual carefully before use, and pay attention to the safety tips inside. Please note that to ensure the life and performance of the tank, deposits inside the tank should be avoided. You need to clean it regularly or use high-efficiency filters or sediment traps (both not included) to clean it. Please confirm the input voltage. Please refer to the nameplate on the machine. Incorrect input voltage can damage the machine. Please note that the water tank should not withstand excessive water flow pressure and should be used by the working load and maximum flow rate of the equipment. If this product is not used for a long time, please restart the motor to ensure that the water is extracted. If the motor does not work: A. If the input voltage is too low, please replace the power supply; B. The starting capacitor may be burnt out, please replace it with a new one. During the welding process, the equipment should always be kept in an open state to prevent damage to the welding gun and cables. Please allow the slight color difference caused by the shooting light and the 1-3 cm error due to manual measurement, and make sure you do not mind before ordering.