Manta M5P V1.0 + CB1 V2.2 Smart Display Control Board — Supports Klipper

Built for Klipper: the Manta M5P V1.0 control board paired with the CB1 V2.2 board can run Klipper directly; if you use the Manta M5P without the CB1 it can run Marlin firmware. CB1 board specifications: CB1 quad-core architecture is 62bit, ARM Cortex-A53 @ 1.5GHz processor with 1GB DDR3. It supports 100M Ethernet + 100M WIFI and can run / support Debian — fully programmable for high speed and stable operation. Onboard multifunctional ports: images can be transmitted to 5/HDMI7 Screen using only an cable, and an SPI interface enables use with SPI touch screens for an intuitive, responsive display. A plug-and-play USB camera is supported for wireless monitoring of your prints. Additional upgrades and hardware notes: integrated SPI and UART mode of driver plus a DIAG pin, easily configured with jumpers. Design uses replaceable components for simple servicing and high-efficiency Mostfet parts to reduce heat generation. MCU firmware can be upgraded via an card, or use DFU via Klipper's make command. After-sales support: if you have any problems about Manta M5P+CB1 board combo sets, please feel to contact us — we have a profession technical supports team ready to assist as soon as possible.