Manta M5P V1.0 + CB1 V2.2 Control Board 64Bit - Upgraded for Klipper Firmware

Ready for Klipper: The Manta M5P V1.0 control board paired with the CB1 V2.2 module can run Klipper firmware directly; if the CB1 is not installed the M5P can run Marlin firmware. CB1 Board details: CB1 is a quad-core 62bit board built around an ARM Cortex-A53 @ 1.5GHz processor with 1GB DDR3 memory, 100M Ethernet +100M WIFI connectivity, and runs Debian (programmable) for high speed and stable operation. Onboard multifunction ports: Video and display signals can be sent to a 5/HDMI7 Screen using a single cable. The SPI interface supports an intuitive, responsive setup and can work with an SPI-connected, plug-and-play USB Camera to monitor printing projects wirelessly. Additional upgrades and expandability: Driver support includes integrated SPI and UART modes plus a DIAG pin, all easily set using jumpers. The board uses replaceable, high-efficiency Mostfet components to reduce heat and simplify maintenance. MCU firmware updates are supported via an card, or by using DFU through Klipper's make command.