LIANXUE BIGTREETECH Manta M5P + CB1 V2.2 64Bit Core Motherboard with TMC2209 for Ender 3 Voron

Designed for Klipper: The BIGTREETECH Manta M5P V1.0 control board paired with the CB1 V2.2 core board can boot a Linux system directly, making it ideal for running Klipper. If the CB1 core board is not used, the Manta M5P can operate with Marlin firmware. CB1 Core Board Details: BIGTREETECH CB1 quad-core architecture is 62bit, ARM Cortex-A53 @ 1.5GHz processor with 1GB DDR3 RAM. It supports 100M Ethernet +100M WIFI, can run Linux (Debian supported) and is fully programmable for high-speed, stable DIY projects. Connectivity and Displays: An onboard HDMI interface lets you send video to a BIGTREETECH HDMI 5/HDMI7 Screen with a single HDMI cable. There is also an SPI interface for use with SPI touch screens, plus a plug-and-play USB camera port to monitor prints wirelessly. Motion and Power Upgrades: The board supports TMC2209 drivers with integrated SPI and UART mode of TMC driver and DIAG pin, all easily set up using jumpers. It uses a replaceable fuse for simple servicing and high efficiency Mostfet components to reduce heat. Firmware and Updating: MCU firmware can be upgraded via an SD card, or you can use DFU via Klipper's make flash command. After-Sales Support: For any questions about the BTT Manta M5P+CB1 core board combo sets, contact us anytime—our professional technical supports team is available to assist.