GENEMA Manta M5P+CB1 Mainboard 64Bit Silent Control Board ARM Cortex-A53 @ 1.5GHz

Designed for Klipper: The BIGTREETECH Manta M5P V1.0 control board paired with the CB1 V2.2 core board can boot a Linux system and run Klipper directly. If the CB1 core board is not installed, the Manta M5P can operate with Marlin firmware. CB1 Core Board: BIGTREETECH CB1 features a quad-core, 62bit architecture with an ARM Cortex-A53 @ 1.5GHz processor and 1GB DDR3 RAM. It supports 100M Ethernet +100M WIFI, runs Linux (Debian supported) and is programmable—providing high speed and stable operation for DIY use. Onboard I/O and peripherals: Includes an HDMI interface so images can be sent to BIGTREETECH HDMI 5/HDMI7 Screen using only an HDMI cable. A built-in SPI interface enables use with SPI touch screens for intuitive, responsive control. The board also accepts a Plug and Play USB Camera for wireless monitoring of your 3D prints. Upgraded hardware features: Supports TMC drivers in both SPI and UART modes and exposes the DIAG pin, with jumper-configurable options for easy setup. The board uses a replaceable fuse and high-efficiency Mostfet components to reduce heat. MCU firmware updates can be applied via an SD card or by using DFU via Klipper's make flash command. After-sales support: If you have any questions about the BTT Manta M5P + CB1 core board combo, contact us any time. Our professional technical support team is available to assist you.