Unbranded E16S Water Heaters 8L 110V sku-17458456228

The Unbranded E16S is a White, 8L electric unit listed under Water Heaters, sku-17458456228, UPC 758483630220. Its title lists 1500W and 110V; the description specifies 2000W maximum heating power. It has an ABS housing, a thickened 304 stainless steel inner liner, intra-membrane injection molding and argon arc welding. The listed construction resists wear, deformation, temperature changes, pressure, tension, acid and alkali, provides insulation and helps prevent water contamination. Heating is direct, with 360° high-density polystyrene insulation for heat retention. A knob adjusts the temperature from 86 to 149℉, and power cuts off when the set temperature is reached. Dimensions are 11.34" x 10.24" x 11.34"; the listed depth is 11.34 inches. It can be installed under a sink or counter on a wall or floor, or placed on a shelf. Hot and cold water pipes are not included. The seller suggests it as a gift and asks customers to contact it with problems. Installation and use notes: 1. Read the manual and safety instructions first. 2. Fill the heater before switching it on to avoid dry burning; do not use it when the water supply stops. 3. Use tap water at 0.1MPA pressure, hot and cold faucets, and a three-plug outlet. For a water tower supply, the specified drop is more than 16.4ft. 4. Install with the water outlet facing upward, never upside down, sideways or backward; insufficient water can cause burnout. 5. If water is too hot, lower the knob setting. Replace the thermostat if the temperature has not decreased within 60 minutes. 6. Do not use outdoors or for showering. Clean the liner regularly to avoid rust: unscrew the inlet and outlet, add soda water (not included), and shake for a few minutes. 7. The unit may work with an existing water heater if sufficient electricity is available. 8. Fit the pressure relief valve at the blue cold-water inlet and use a reliable electrical outlet. Improper installation poses electrical safety hazards; installation should be done by professionals. 9. Fit a safety valve at the top of the tank. Dripping during pressure relief can occur; connect a pipe to a drain. 10. Allow for lighting-related color variation and a manual-measurement error of 1-3cm.